Winchester-repeating-arms 101 Instrukcja Użytkownika

Winchester Repeating Arms 275 Winchester Avenue Morgan, UT, USA 84050-9333 winchesterguns.comWinchester is a registered trademark of Olin Corporation.

FIGURE 5 8Stocks are profiled for an ideal fit, fast handling and reduced felt recoil on the face. Special models feature an adjustable comb for a per

FIGURE 5 8Stocks are profiled for an ideal fit, fast handling and reduced felt recoil on the face. Special models feature an adjustable comb for a per

extractors/ejectors, hinge surfaces and the chamber areas. A high quality, lightweight gun oil should be used to remove this compound and to give your

extractors/ejectors, hinge surfaces and the chamber areas. A high quality, lightweight gun oil should be used to remove this compound and to give your

•Iftheletter“O”isexposed,theover(top)barrelwillfire first (Figure 11, page 12). Often different chokes are installed in each barrel which

•Iftheletter“O”isexposed,theover(top)barrelwillfire first (Figure 11, page 12). Often different chokes are installed in each barrel which

the muzzles at a downward angle with respect to the receiver. Then push the top lever to the right. Carefully engage the surfaces of the trunnions (lo

the muzzles at a downward angle with respect to the receiver. Then push the top lever to the right. Carefully engage the surfaces of the trunnions (lo

ammunitionUSE ONLY SHELLS OF THE CORRECT GAUGE AND LENGTH. THE GAUGE AND LENGTH OF THE CHAMBER IS INSCRIBED ON THE SIDE OF THE BARREL. DO NOT USE AMMU

ammunitionUSE ONLY SHELLS OF THE CORRECT GAUGE AND LENGTH. THE GAUGE AND LENGTH OF THE CHAMBER IS INSCRIBED ON THE SIDE OF THE BARREL. DO NOT USE AMMU

State WarningAccording to state law, California requires that firearm manufacturers, distributors and retailers include conspicuous, specific warnings

THE SHOTGUN IS NOW READY TO FIRE BY SIMPLY MOVING THE “SAFETY” TO THE OFF SAFE POSITION AND PULLING THE TRIGGER. 6. Select the barrel you want to fir

THE SHOTGUN IS NOW READY TO FIRE BY SIMPLY MOVING THE “SAFETY” TO THE OFF SAFE POSITION AND PULLING THE TRIGGER. 6. Select the barrel you want to fir

downward slightly on the forearm to completely open the breech. For proper ejection, keep the receiver level and allow the barrels to completely drop.

downward slightly on the forearm to completely open the breech. For proper ejection, keep the receiver level and allow the barrels to completely drop.

22 23choke tube inStallation1. Place the “safety”/selector in the on safe position. Always make sure the shotgun is completely unloaded. Always keep

22 23choke tube inStallation1. Place the “safety”/selector in the on safe position. Always make sure the shotgun is completely unloaded. Always keep

24 25aDjuStable Stock (Special moDelS)BEFORE PERFORMING STOCK ADJUSTMENT PROCEDURES, PLACE THE “SAFETY” IN THE ON SAFE POSITION. OPEN THE ACTION AND

24 25aDjuStable Stock (Special moDelS)BEFORE PERFORMING STOCK ADJUSTMENT PROCEDURES, PLACE THE “SAFETY” IN THE ON SAFE POSITION. OPEN THE ACTION AND

26 27adjustment on each stud is equal up and down. When you have determined a possible setting, lightly tighten the stock adjustment screws and then

26 27adjustment on each stud is equal up and down. When you have determined a possible setting, lightly tighten the stock adjustment screws and then

State WarningAccording to state law, California requires that firearm manufacturers, distributors and retailers include conspicuous, specific warnings

28 29action wiped clean and oiled after every day of shooting. Normal maintenance can be accomplished with the barrels still attached to the receiver

28 29action wiped clean and oiled after every day of shooting. Normal maintenance can be accomplished with the barrels still attached to the receiver

30 31choke tube and the internal threads of the barrel should be cleaned after each use and before the installation of a tube.3. Be careful when rem

30 31choke tube and the internal threads of the barrel should be cleaned after each use and before the installation of a tube.3. Be careful when rem

325. If convenient, send a copy of the service/repair form or letter to us separately.6. Never return ammunition with your firearm. It is against p

325. If convenient, send a copy of the service/repair form or letter to us separately.6. Never return ammunition with your firearm. It is against p

Winchester Repeating Arms 275 Winchester Avenue Morgan, UT, USA 84050-9333 winchesterguns.comWinchester is a registered trademark of Olin Corporation.

This can occur even with the “safety” in the on safe position. Be extremely careful while hunting or during any shooting activity to avoid dropping an

This can occur even with the “safety” in the on safe position. Be extremely careful while hunting or during any shooting activity to avoid dropping an

no obstructions remain in the barrel. Completely clear the barrel before loading and firing again. Failure to follow these instructions can cause exte

no obstructions remain in the barrel. Completely clear the barrel before loading and firing again. Failure to follow these instructions can cause exte

6 725 WE RESERVE THE RIGHT TO REFUSE SERVICE ON FIREARMS THAT HAVE BEEN ALTERED, ADDED TO OR SUBSTANTIALLY CHANGED. Removal of metal from the barre

6 725 WE RESERVE THE RIGHT TO REFUSE SERVICE ON FIREARMS THAT HAVE BEEN ALTERED, ADDED TO OR SUBSTANTIALLY CHANGED. Removal of metal from the barre